When was the last time you checked your garden walls or if you are buying had a look to see what the walls are like? The repair and replacement of brick and masonry garden walls can be considerable – the most recent wall reconstruction that we managed on behalf of a client cost over £10,000 for a 14m run of brick and block retaining wall on new footings and it wasn’t that high! Sometimes the cost of repair can be shared with a neighbour if the garden wall is a party fence wall as described in the party wall etc act.
According to what used to be the OPDM and is now something else garden and boundary walls should be inspected from time to time to see if any repairs are necessary. In some cases damage such as leans or leaning piers may require walls to be rebuilt
What was OPDM also stated that garden and boundary walls are amongst the most common forms of masonry to suffer collapse, and they are unfortunately one of the commonest causes of death by falling masonry!
When we carry out a building survey we inspect the garden alls and quite often come across walls that are very misaligned and leaning often dangerously. Sometimes it is brick piers and parts of walls that are deteriorated rather than the wall itself bit all need prompt and potentially expensive attention.
Things to look for –
Is the surface of the masonry flaking or eroded?
This often occurs as a result of freeze thaw action but in some cases the bricks become very damaged, if this is widespread then a wall can become unstable as its effective thickness is reduced. Replacement of affected bricks or localised reconstruction may be necessary.
What is the pointing like?
The pointing is the mortar joints between the brickwork, this can erode and fall away particularly if the original mix was poor and perhaps too sandy, if there are big or deep gaps then a wall may well be unstable and need attention. Catch it early enough and it may just be repointing! Bank on about £40/square metre and make sure the old mortar is raked out to about 15mm depth. We recommend that climbing plants such as Ivy are removed as these can damage both the pointing and the surface of the bricks as described above.
Is the wall leaning?
Walls lean for a variety of reasons. Typically tree roots can grow and cause heave and put pressure on wall or footings or damage can occur to the foundations in the same way that subsidence affects a building. If a wall is “retaining” that is it olds back ground then it should incorporate weep holes to allow water pressure behind to be relieved.
I was once told that he only truly stable wall is one that is flat on the floor but in reality if your wall leans to around about 50% of its width then it may need attention so if a single brick wall – approx 230mm – is out of square by 100mm between top and bottom it may need attention. If in doubt ask a chartered building surveyor or similar professional because a garden wall collapsing onto a pavement can be very dangerous.
Is the wall thick enough for its height or low enough for its width?
If you used to play with Lego as a child you will remember that very tall thin structures always fell over. Well, the same is true of real walls and care needs to be taken to ensure that wall is not built too high for its width.
The ratio of height to width varies around the country and can vary according to prevailing weather conditions and variable ground conditions but as a guide in the south east a brick wall 230mm wide [“one brick thick”] can usually be safely built to a height of 1450mm [about 3’6”, so not very high]. A wall 325mm wide [“one and a half brick thick”] can go up to about 2400mm.
Different materials will vary and it may be possible to introduce forms f reinforcement that can improve these performances. All walls should have adequate footings properly designed for their situation – the temptation to just dig a shallow trench slop in some concrete and build a wall must be avoided!.
Is the finish on top of the wall firmly attached?
The top of a wall is usually finished with brick on edge copings or concrete copings and these may have become loose. They can be tested quite easily by hand, we recommend finishing walls with a harder engineering brick on edge or specialist copings as these protect the head of the wall from premature failure.
Are there any cracks in the wall?
What we describe as hairline cracks (0-2mm across) are very common in all sorts of walls and may not indicate serious problems, very often they are due to thermal movements within that structure. Sometimes these fractures become bigger – usually it
is good practice to build into walls a movement joint – the spacings vary but typically every six metres or so, these special joints allow for some movement to occur in the wall without causing cracking. It is important that you find out why the cracks are there rather than just covering them up because aesthetic repair does not resolve underlying structural problems that may cause failure.
If in doubt seek professional advice, although the repair of walls can be expensive if they were to fall and injure [or worse] someone or cause an accident the potential costs can be staggering! Insurers may well review their cover if a wall has not been properly or adequately maintained. If you are buying a house make sure your surveyor check the boundary walls and that your solicitor checks who is responsible for repairing them and do not be frightened to negotiate in price if the walls need rebuilding.
The party wall act contains provisions for shared repairing costs where the wall is shared or described as a “party fence wall”. You may need to consult a specialist party wall surveyor in this regard, particularly if you are having difficulty in agreeing how to share the costs with your neighbour.
The three pictures below illustrate some of the walls we’ve found or repaired:
- A garden wall in south London, know as a “rat run” wall there are two leaves with a hollow in the middle and a coping, this wall has missing bricks, rotten pointing, plant growth to the top and a slight lean.
- A boundary wall that acts a retaining wall, it’s not very high but it is now not stable and could in our opinion fail at any time, the brick facings have failed and the worst point of failure is right next to a road crossing.
- Finally these walls in Kent have recently been repaired and we have added a contrasting engineering brick coping on top to replace the original brick on edge which had comprehensibly failed.